A new experimental technique for the accurate measurement of steady-state metal temperature surface distributions of modern heavily film-cooled turbine vanes has been developed and is described in this paper. The technique is analogous to the thermal paint test but has been designed for fundamental research. The experimental facility consists of an annular sector cascade of high pressure (HP) turbine vanes from a current production engine. Flow conditioning is achieved by using an annular sector of deswirl vanes downstream of the test section, being both connected by a three-dimensionally contoured duct. As a result, a transonic and periodic flow, highly representative of the engine aerodynamic field, is established: Inlet turbulence levels, mainstream Mach and Reynolds numbers, and coolant-to-mainstream total pressure ratio are matched. Since the fully three-dimensional nozzle guide vane (NGV) geometry is used, the correct radial pressure gradient and secondary flow development are simulated and the cooling flow redistribution is engine-realistic. To allow heat transfer measurements to be performed, a mainstream-to-coolant temperature difference (up to ) is generated by using two steel-wire mesh heaters, operated in series. NGV surface metal temperatures are measured (between and ) by wide-band thermochromic liquid crystals. These are calibrated in situ and on a per-pixel basis against vane surface thermocouples, in a heating process that spans the entire color play and during which the turbine vanes can be assumed to slowly follow a succession of isothermal states. Experimental surface distributions of overall cooling effectiveness are presented in this paper. By employing resin vanes of the same geometry and cooling configuration (to implement adiabatic wall thermal boundary conditions) and the transient liquid crystal technique, surface distributions of external heat transfer coefficient and film cooling effectiveness can be acquired. By combining these measurements with those from the metal vanes, the results can be scaled to engine conditions with a good level of accuracy.
Skip Nav Destination
Article navigation
July 2011
Research Papers
A Novel Technique for Assessing Turbine Cooling System Performance
S. Luque
Department of Engineering Science,
University of Oxford
, Parks Road, Oxford OX1 3PJ, UK
T. Povey
Department of Engineering Science,
University of Oxford
, Parks Road, Oxford OX1 3PJ, UK
J. Turbomach. Jul 2011, 133(3): 031013 (9 pages)
Published Online: November 15, 2010
Article history
Received:
August 19, 2009
Revised:
October 20, 2009
Online:
November 15, 2010
Published:
November 15, 2010
Citation
Luque, S., and Povey, T. (November 15, 2010). "A Novel Technique for Assessing Turbine Cooling System Performance." ASME. J. Turbomach. July 2011; 133(3): 031013. https://doi.org/10.1115/1.4001232
Download citation file:
Get Email Alerts
Related Articles
Effects of Trenched Holes on Film Cooling of a Contoured Endwall Nozzle Vane
J. Turbomach (July,2012)
Investigation of Detailed Film Cooling Effectiveness and Heat Transfer Distributions on a Gas Turbine Airfoil
J. Turbomach (April,1999)
Influence of Surface Roughness on Heat Transfer and Effectiveness for a Fully Film Cooled Nozzle Guide Vane Measured by Wide Band Liquid Crystals and Direct Heat Flux Gages
J. Turbomach (October,2000)
Estimating the Loss Associated With Film Cooling for a Turbine Stage
J. Turbomach (March,2012)
Related Proceedings Papers
Related Chapters
Control and Operational Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Engineering and Physical Modeling of Power Plant Cooling Systems
Thermal Power Plant Cooling: Context and Engineering
Thermodynamic Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential