Volume-filling ratio of the working fluid has a predominant effect on the system performance of a closed two-phase solar water-heating (SWH) system. To study this effect, a prototype of a loop thermosyphon SWH system, which uses remolded flat-plate solar collector as the evaporator and the coil pipe in the water tank as the condenser, was set up. A set of long-term outdoor experiments under 10%, 20%, 30%, 50%, and 70% volume-filling ratios were conducted in this paper. R600a was used as working fluid. Loop thermosyphon solar collector thermal performance and system thermal performance under different volume-filling ratios, including the temperature distribution of loop thermosyphon evaporator, were presented. It is shown that the loop thermosyphon solar collector and the system had a better thermal performance than the conventional ones under 30% and 50% volume-filling ratio, and the loop thermosyphon evaporator had an even temperature distribution when the volume-filling ratio was higher than 30%. The optimum volume filing ratio lies in between 30% and 50% of the whole system volume.
Skip Nav Destination
Article navigation
August 2016
Research-Article
Investigation on the Optimum Volume-Filling Ratio of a Loop Thermosyphon Solar Water-Heating System
Tao Zhang,
Tao Zhang
College of Energy and Mechanical Engineering,
Shanghai University of Electric Power,
#2103 Pingliang Road,
Shanghai 200090, China
e-mail: zhtyn86@163.com
Shanghai University of Electric Power,
#2103 Pingliang Road,
Shanghai 200090, China
e-mail: zhtyn86@163.com
Search for other works by this author on:
Gang Pei,
Gang Pei
Department of Thermal Science
and Energy Engineering,
University of Science and Technology of China,
#96 Jinzhai Road,
Hefei, Anhui 230026, China
e-mail: peigang@ustc.edu.cn
and Energy Engineering,
University of Science and Technology of China,
#96 Jinzhai Road,
Hefei, Anhui 230026, China
e-mail: peigang@ustc.edu.cn
Search for other works by this author on:
Qunzhi Zhu,
Qunzhi Zhu
College of Energy and Mechanical Engineering,
Shanghai University of Electric Power,
#2103 Pingliang Road,
Shanghai 200090, China
e-mail: zhuqzgt@163.com
Shanghai University of Electric Power,
#2103 Pingliang Road,
Shanghai 200090, China
e-mail: zhuqzgt@163.com
Search for other works by this author on:
Jie Ji
Jie Ji
Department of Thermal Science and Energy
Engineering,
University of Science and Technology of China,
#96 Jinzhai Road,
Hefei, Anhui 230026, China
e-mail: jijie@ustc.edu.cn
Engineering,
University of Science and Technology of China,
#96 Jinzhai Road,
Hefei, Anhui 230026, China
e-mail: jijie@ustc.edu.cn
Search for other works by this author on:
Tao Zhang
College of Energy and Mechanical Engineering,
Shanghai University of Electric Power,
#2103 Pingliang Road,
Shanghai 200090, China
e-mail: zhtyn86@163.com
Shanghai University of Electric Power,
#2103 Pingliang Road,
Shanghai 200090, China
e-mail: zhtyn86@163.com
Gang Pei
Department of Thermal Science
and Energy Engineering,
University of Science and Technology of China,
#96 Jinzhai Road,
Hefei, Anhui 230026, China
e-mail: peigang@ustc.edu.cn
and Energy Engineering,
University of Science and Technology of China,
#96 Jinzhai Road,
Hefei, Anhui 230026, China
e-mail: peigang@ustc.edu.cn
Qunzhi Zhu
College of Energy and Mechanical Engineering,
Shanghai University of Electric Power,
#2103 Pingliang Road,
Shanghai 200090, China
e-mail: zhuqzgt@163.com
Shanghai University of Electric Power,
#2103 Pingliang Road,
Shanghai 200090, China
e-mail: zhuqzgt@163.com
Jie Ji
Department of Thermal Science and Energy
Engineering,
University of Science and Technology of China,
#96 Jinzhai Road,
Hefei, Anhui 230026, China
e-mail: jijie@ustc.edu.cn
Engineering,
University of Science and Technology of China,
#96 Jinzhai Road,
Hefei, Anhui 230026, China
e-mail: jijie@ustc.edu.cn
1Corresponding author.
Contributed by the Solar Energy Division of ASME for publication in the JOURNAL OF SOLAR ENERGY ENGINEERING: INCLUDING WIND ENERGY AND BUILDING ENERGY CONSERVATION. Manuscript received June 30, 2015; final manuscript received April 7, 2016; published online May 5, 2016. Assoc. Editor: Werner Platzer.
J. Sol. Energy Eng. Aug 2016, 138(4): 041006 (10 pages)
Published Online: May 5, 2016
Article history
Received:
June 30, 2015
Revised:
April 7, 2016
Citation
Zhang, T., Pei, G., Zhu, Q., and Ji, J. (May 5, 2016). "Investigation on the Optimum Volume-Filling Ratio of a Loop Thermosyphon Solar Water-Heating System." ASME. J. Sol. Energy Eng. August 2016; 138(4): 041006. https://doi.org/10.1115/1.4033403
Download citation file:
Get Email Alerts
A Nonintrusive Optical Approach to Characterize Heliostats in Utility-Scale Power Tower Plants: Camera Position Sensitivity Analysis
J. Sol. Energy Eng (December 2024)
A Solar Air Receiver With Porous Ceramic Structures for Process Heat at Above 1000 °C—Heat Transfer Analysis
J. Sol. Energy Eng (April 2025)
View Factors Approach for Bifacial Photovoltaic Array Modeling: Bifacial Gain Sensitivity Analysis
J. Sol. Energy Eng (April 2025)
Resources, Training, and Education Under the Heliostat Consortium: Industry Gap Analysis and Building a Resource Database
J. Sol. Energy Eng (December 2024)
Related Articles
Energetic and Exergetic Performance of a Solar Flat-Plate Collector Working With Cu Nanofluid
J. Sol. Energy Eng (June,2018)
Numerical Investigation of Thermal Separators Within the Evacuated Tubes of a Water-in-Glass Solar Water Heater
J. Sol. Energy Eng (December,2018)
State Space Model for Thermal Analysis of Integrated Structure of Flat Plate Solar Collector and Building Envelope
J. Sol. Energy Eng (December,2015)
S-Ethane Brayton Power Conversion Systems for Concentrated Solar Power Plant
J. Sol. Energy Eng (February,2016)
Related Proceedings Papers
Related Chapters
The Special Characteristics of Closed-Cycle Gas Turbines
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Scope of Section I, Organization, and Service Limits
Power Boilers: A Guide to the Section I of the ASME Boiler and Pressure Vessel Code, Second Edition
Solar Energy Storage in Water
Case Studies in Transient Heat Transfer With Sensitivities to Governing Variables