A high-temperature high-concentration pressurized-air solar receiver is considered for driving a power generation Brayton cycle. The modular design consists of a cylindrical SiC cavity surrounded by a concentric annular reticulated porous ceramic (RPC) foam contained in a stainless steel pressure vessel, with a secondary concentrator attached to its windowless aperture. Experimentation was carried out in a solar tower for up to 47 kW of concentrated solar radiative power input in the absolute pressure range of 2-6 bar. Peak outlet air temperatures exceeding 1200 °C were reached for an average solar concentration ratio of 2500 suns. A notable thermal efficiency—defined as the ratio of the enthalpy change of the air flow divided by the solar radiative power input through the aperture—of 91% was achieved at 700 °C and 4 bar.
Skip Nav Destination
Article navigation
June 2015
Research-Article
Modular Design and Experimental Testing of a 50 kWth Pressurized-Air Solar Receiver for Gas Turbines
Peter Poživil,
Peter Poživil
Department of Mechanical
and Process Engineering,
and Process Engineering,
ETH Zürich
,Zürich 8092
, Switzerland
Search for other works by this author on:
Nicolas Ettlin,
Nicolas Ettlin
Department of Mechanical
and Process Engineering,
and Process Engineering,
ETH Zürich
,Zürich 8092
, Switzerland
Search for other works by this author on:
Fabian Stucker,
Fabian Stucker
Department of Mechanical
and Process Engineering,
and Process Engineering,
ETH Zürich
,Zürich 8092
, Switzerland
Search for other works by this author on:
Aldo Steinfeld
Aldo Steinfeld
1
Department of Mechanical
and Process Engineering,
and Process Engineering,
ETH Zürich
,Zürich 8092
, Switzerland
Solar Technology Laboratory,
e-mail: aldo.steinfeld@ethz.ch
Paul Scherrer Institute
,Villigen 5232
, Switzerland
e-mail: aldo.steinfeld@ethz.ch
1Corresponding author.
Search for other works by this author on:
Peter Poživil
Department of Mechanical
and Process Engineering,
and Process Engineering,
ETH Zürich
,Zürich 8092
, Switzerland
Nicolas Ettlin
Department of Mechanical
and Process Engineering,
and Process Engineering,
ETH Zürich
,Zürich 8092
, Switzerland
Fabian Stucker
Department of Mechanical
and Process Engineering,
and Process Engineering,
ETH Zürich
,Zürich 8092
, Switzerland
Aldo Steinfeld
Department of Mechanical
and Process Engineering,
and Process Engineering,
ETH Zürich
,Zürich 8092
, Switzerland
Solar Technology Laboratory,
e-mail: aldo.steinfeld@ethz.ch
Paul Scherrer Institute
,Villigen 5232
, Switzerland
e-mail: aldo.steinfeld@ethz.ch
1Corresponding author.
Contributed by the Solar Energy Division of ASME for publication in the JOURNAL OF SOLAR ENERGY ENGINEERING: INCLUDING WIND ENERGY AND BUILDING ENERGY CONSERVATION. Manuscript received May 20, 2014; final manuscript received October 19, 2014; published online November 17, 2014. Assoc. Editor: Markus Eck.
J. Sol. Energy Eng. Jun 2015, 137(3): 031002 (7 pages)
Published Online: June 1, 2015
Article history
Received:
May 20, 2014
Revision Received:
October 19, 2014
Online:
November 17, 2014
Citation
Poživil, P., Ettlin, N., Stucker, F., and Steinfeld, A. (June 1, 2015). "Modular Design and Experimental Testing of a 50 kWth Pressurized-Air Solar Receiver for Gas Turbines." ASME. J. Sol. Energy Eng. June 2015; 137(3): 031002. https://doi.org/10.1115/1.4028918
Download citation file:
Get Email Alerts
A Nonintrusive Optical Approach to Characterize Heliostats in Utility-Scale Power Tower Plants: Camera Position Sensitivity Analysis
J. Sol. Energy Eng (December 2024)
A Solar Air Receiver With Porous Ceramic Structures for Process Heat at Above 1000 °C—Heat Transfer Analysis
J. Sol. Energy Eng (April 2025)
View Factors Approach for Bifacial Photovoltaic Array Modeling: Bifacial Gain Sensitivity Analysis
J. Sol. Energy Eng (April 2025)
Resources, Training, and Education Under the Heliostat Consortium: Industry Gap Analysis and Building a Resource Database
J. Sol. Energy Eng (December 2024)
Related Articles
Numbering-Up of Microscale Devices for Megawatt-Scale Supercritical Carbon Dioxide Concentrating Solar Power Receivers
J. Sol. Energy Eng (December,2016)
Modeling of a Solar Receiver for Superheating Sulfuric Acid
J. Sol. Energy Eng (August,2016)
Numerical Heat Transfer Analysis of a 50 kW th Pressurized-Air Solar Receiver
J. Sol. Energy Eng (December,2015)
Thermo-Fluid Optimization of a Solar Porous Absorber With a Variable Pore Structure
J. Sol. Energy Eng (October,2017)
Related Proceedings Papers
Related Chapters
Our Sun and Thermal Radiation Distribution Function
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life
Human Thermal Comfort
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life
Development of Nuclear Boiler and Pressure Vessels in Taiwan
Global Applications of the ASME Boiler & Pressure Vessel Code