Since the early 1960s, the laser flash method of thermal diffusivity measurement has been used on a large variety of materials. Several parameter estimation methods have also been used in analyzing such experiments, employing various levels of sophistication. Estimation of thermal parameters, using the models developed as part of this research, is performed on experimental data from the Oak Ridge National Laboratory in Oak Ridge, TN. The material used is carbon bonded carbon fiber (CBCF) which is designed as an insulating material for atmosphere re-entry applications. Ambient temperatures in the experiments range from 800°C to 1200°C. The approximate thermal diffusivity of the material is 0.3 mm2/sec. This research investigates the penetration of the laser flash beyond the surface of the material being heated. Three heat transfer models are presented, each with different assumptions about the initial temperature distribution inside the material. An evaluation is made of the response of the methods to factors which may enter into the experimental process. This is done in quantitative terms so as to assess the adequacy of the models in comparison to one another.

Issue Section:
Properties and Property Measurements
Keywords:
Absorption, Conduction, Heat Transfer, Inverse, Properties, Radiation
Topics:
Accounting, Heat transfer, Heating, Lasers, Thermal diffusivity, Absorption, Carbon, Carbon fibers, Heat conduction, Insulation, Parameter estimation, Radiation (Physics), Temperature, Temperature distribution
1.
Beck, J., and Osman, A., 1991, “Sequential Estimation of Temperature Dependent Thermal Properties,” High Temperatures–High Pressures, Vol. 23.
2.
Beck, J., Cole, K., Haji-Sheikh, A., and Litkouhi, B., 1992, Heat Conduction Using Green’s Functions, Hemisphere Publishing, Washington DC.
3.
Beck, J., and Dinwiddie, R., 1996, “Parameter Estimation Method for Flash Thermal Diffusivity with Two Different Heat Transfer Coefficients,” Proceedings from 23rd Thermal Conductivity Conference, Technomic Publishing, Lancaster, PA.
4.
Beck, J., 1998, “Parameter Estimation Concepts and Flash Diffusivity Application,” Proceedings of the Second International Conference on inverse problems in Engineering: Theory and Practice, Le Croisic, France, to be published.
5.
Beck, J., 1999, “Inverse Problems in Heat Transfer,” Proceedings of the Institute of Mathematics and its Applications Conference, Bradford England, to be published.
6.
Clark
L.
, and
Taylor
R.
,
1975
, “
Radiation Loss in the Flash Method for Thermal Diffusivity
,”
Journal of Applied Physics
, Vol.
26
, No.
2
, pp.
714
–
719
.
7.
Cowan
R.
,
1963
, “
Pulse Method of Measuring Thermal Diffusivity at High Temperature
,”
Journal of Applied Physics
, Vol.
34
, No.
4
, pp.
926
–
927
.
8.
Koski, J., 1981, Improved Data Reduction Methods for Laser Pulse Diffusivity Determination with the use of Minicomputers, National Technical Information Service, Springfield Va.
9.
Parker
W.
,
Jenkins
,
Butler
C.
, and
Abbott
G.
,
1961
, “
Flash Method of Determining Thermal Diffusivity, Heat Capacity and Thermal Conductivity
,”
Journal of Applied Physics
, Vol.
32
, No.
9
, pp.
1679
–
1684
.
10.
Raynaud, M., Beck, J., Shoemaker, R., and Taylor, R., 1989, “Sequential Estimation of Thermal Diffusivity for Flash Tests,” Proceedings from 20th Thermal Conductivity Conference, Plenum Publishing, pp. 305–321.
11.
Siegel, R., and Howell, J., 1981, Thermal Radiation Heat Transfer, Hemisphere, New York.
12.
Taylor
R.
,
1979
, “
Heat Pulse Thermal Diffusivity Measurements
,”
High Temperatures-High Pressures
, Vol.
11
, pp.
43
–
58
.
13.
Thermitus, M., and Laurent, M., 1997, “New Logarithmic Technique in the Flash Method,” International Journal of Heat and Mass Transfer, Vol. 40, No. 17.
This content is only available via PDF.
Copyright © 1999
 by The American Society of Mechanical Engineers
You do not currently have access to this content.