Solid Oxide Fuel Cell (SOFC) developers are presently considering both internal and external reforming fuel cell designs. Generally, the endothermic reforming reaction and excess air through the cathode provide the cooling needed to remove waste heat from the fuel cell. Current information suggests that external reforming fuel cells will require a flow rate twice the amount necessary for internal reforming fuel cells. The increased airflow could negatively impact system performance. This paper compares the performance among various external reforming hybrid configurations and an internal reforming hybrid configuration. A system configuration that uses the reformer to cool a cathode recycle stream is introduced, and a system that uses interstage external reforming is proposed. Results show that the thermodynamic performance of these proposed concepts are an improvement over a base-concept external approach, and can be better than an internal reforming hybrid system, depending on the fuel cell cooling requirements.
Skip Nav Destination
e-mail: eric.liese@netl.doe.gov
Article navigation
January 2005
Technical Papers
Performance Comparison of Internal Reforming Against External Reforming in a Solid Oxide Fuel Cell, Gas Turbine Hybrid System
Eric A. Liese,
e-mail: eric.liese@netl.doe.gov
Eric A. Liese
National Energy Technology Laboratory, 3610 Collins Ferry Road, Morgantown, WV 26507
Search for other works by this author on:
Randall S. Gemmen
Randall S. Gemmen
National Energy Technology Laboratory, 3610 Collins Ferry Road, Morgantown, WV 26507
Search for other works by this author on:
Eric A. Liese
National Energy Technology Laboratory, 3610 Collins Ferry Road, Morgantown, WV 26507
e-mail: eric.liese@netl.doe.gov
Randall S. Gemmen
National Energy Technology Laboratory, 3610 Collins Ferry Road, Morgantown, WV 26507
Contributed by the International Gas Turbine Institute (IGTI) of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Paper presented at the International Gas Turbine and Aeroengine Congress and Exhibition, Atlanta, GA, June 16–19, 2003, Paper No. 2003-GT-38566. Manuscript received by IGTI, Oct. 2002; final revision, Mar. 2003. Associate Editor: H. R. Simmons.
J. Eng. Gas Turbines Power. Jan 2005, 127(1): 86-90 (5 pages)
Published Online: February 9, 2005
Article history
Received:
October 1, 2002
Revised:
March 1, 2003
Online:
February 9, 2005
Citation
Liese, E. A., and Gemmen, R. S. (February 9, 2005). "Performance Comparison of Internal Reforming Against External Reforming in a Solid Oxide Fuel Cell, Gas Turbine Hybrid System ." ASME. J. Eng. Gas Turbines Power. January 2005; 127(1): 86–90. https://doi.org/10.1115/1.1788689
Download citation file:
Get Email Alerts
Temperature Dependence of Aerated Turbine Lubricating Oil Degradation from a Lab-Scale Test Rig
J. Eng. Gas Turbines Power
Multi-Disciplinary Surrogate-Based Optimization of a Compressor Rotor Blade Considering Ice Impact
J. Eng. Gas Turbines Power
Experimental Investigations on Carbon Segmented Seals With Smooth and Pocketed Pads
J. Eng. Gas Turbines Power
Related Articles
Thermo-Economic Optimization of a Solid Oxide Fuel Cell, Gas Turbine Hybrid System
J. Fuel Cell Sci. Technol (May,2007)
The Effect of Size on Optimization of Solid Oxide Fuel Cell/Gas Turbine Hybrid Cycles
J. Eng. Gas Turbines Power (September,2010)
Cycle Analysis of Gas Turbine–Fuel Cell Cycle Hybrid Micro Generation System
J. Eng. Gas Turbines Power (October,2004)
Design and Off-Design Analysis of a MW Hybrid System Based on Rolls-Royce Integrated Planar Solid Oxide Fuel Cells
J. Eng. Gas Turbines Power (July,2007)
Related Proceedings Papers
Related Chapters
Exergy Analysis of Gas Turbine – Molten Carbonate Fuel Cell Hybrid Power Plant
International Conference on Software Technology and Engineering (ICSTE 2012)
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Control and Operational Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential