Combustors with fuel-spray atomizers are particularly susceptible to a low-frequency oscillation at idle and subidle conditions. For aeroengine combustors, the frequency of this oscillation is typically in the range 50–120 Hz and is commonly called “rumble.” The mechanism involves interaction between the plenum around the burner and the combustion chamber. Pressure variations in the plenum or the combustor alter the inlet air and fuel spray characteristics, thereby changing the rate of combustion. This in turn leads to local “hot spots” which generate pressure oscillations as they convect through the downstream nozzle. In order to eliminate the combustion oscillations, it is essential to determine which fuel atomizers are particularly likely to lead to instability by quantifying their sensitivity to flow perturbations. This can be done by identifying the system through understanding the transfer function, which represents the relationship between the unsteadiness of combustion and the inlet fuel and air. In the present work, various types of signals are applied to produce a small change in the inlet fuel and air flow rates, the response in the rate of heat release caused downstream was calculated and stored for subsequent analysis. Afterwards, the system transfer function is calculated by determining the coefficients of an IIR filter (Infinite Impulse Response) for which the output signal is the downstream heat release rate and the input signal is the inlet flow rate. The required transfer function then follows from the Fourier transform of this relationship. The resulting transfer functions are compared with those obtained by the forced harmonic oscillations at a fixed given frequency. Suitably chosen input signals accurately recover the results for harmonic forcing at a single frequency, but also give detailed information about the combustor response over a wide frequency range. There are two distinct forms to the low-frequency quasisteady response. In the primary zone, the rate of combustion is influenced by the turbulence and is enhanced when the inlet air velocity is large. Near the edge of combustion zone, the rate of combustion depends on the mixture fraction and is high when the mixture fraction is close to the stoichiometric value. This generates ‘hot spots’ which convect into the dilution zone. At higher frequencies, the combustion lags this quasi-steady response through simple lag-laws and the relevant time delays have been identified.
Skip Nav Destination
Article navigation
January 2005
Technical Papers
Transfer Function Calculations for Aeroengine Combustion Oscillations
M. Zhu,
M. Zhu
Department of Thermal Engineering, Tsinghua University, Beijing 100084, China
Search for other works by this author on:
A. P. Dowling,
A. P. Dowling
Department of Engineering, University of Cambridge, Trumpington Street, Cambridge CB2 1PZ, UK
Search for other works by this author on:
K. N. C. Bray
K. N. C. Bray
Department of Engineering, University of Cambridge, Trumpington Street, Cambridge CB2 1PZ, UK
Search for other works by this author on:
M. Zhu
Department of Thermal Engineering, Tsinghua University, Beijing 100084, China
A. P. Dowling
Department of Engineering, University of Cambridge, Trumpington Street, Cambridge CB2 1PZ, UK
K. N. C. Bray
Department of Engineering, University of Cambridge, Trumpington Street, Cambridge CB2 1PZ, UK
Contributed by the International Gas Turbine Institute (IGTI) of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Paper presented at the International Gas Turbine and Aeroengine Congress and Exhibition, New Orleans, LA, June 4–7, 2001; Paper 2001-GT-0374. Manuscript received by IGTI, December 2000, final revision, March 2001. Associate Editor: R. Natole.
J. Eng. Gas Turbines Power. Jan 2005, 127(1): 18-26 (9 pages)
Published Online: February 9, 2005
Article history
Received:
December 1, 2000
Revised:
March 1, 2001
Online:
February 9, 2005
Citation
Zhu, M., Dowling , A. P., and Bray, K. N. C. (February 9, 2005). "Transfer Function Calculations for Aeroengine Combustion Oscillations ." ASME. J. Eng. Gas Turbines Power. January 2005; 127(1): 18–26. https://doi.org/10.1115/1.1806451
Download citation file:
Get Email Alerts
Temperature Dependence of Aerated Turbine Lubricating Oil Degradation from a Lab-Scale Test Rig
J. Eng. Gas Turbines Power
Multi-Disciplinary Surrogate-Based Optimization of a Compressor Rotor Blade Considering Ice Impact
J. Eng. Gas Turbines Power
Experimental Investigations on Carbon Segmented Seals With Smooth and Pocketed Pads
J. Eng. Gas Turbines Power
Related Articles
A Time-Domain Network Model for Nonlinear Thermoacoustic Oscillations
J. Eng. Gas Turbines Power (May,2009)
Thermoacoustic Modeling of a Gas Turbine Using Transfer Functions Measured Under Full Engine Pressure
J. Eng. Gas Turbines Power (November,2010)
Advanced Closed-Loop Control on an Atmospheric Gaseous Lean-Premixed Combustor
J. Eng. Gas Turbines Power (October,2004)
Combustion Instabilities and Control of a Multiswirl Atmospheric Combustor
J. Eng. Gas Turbines Power (January,2007)
Related Chapters
A Simple Carburetor
Case Studies in Fluid Mechanics with Sensitivities to Governing Variables
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Combustion Under Harmonically Oscillating Pressure
Theory of Solid-Propellant Nonsteady Combustion